![]() ![]() Situation 2. Acronis not recognizing WD HDD/SSD. Acronis True Image WD edition does not support the exFAT file system, so Acronis won’t recognize it and you cannot use a hard drive formatted as ExFAT as the target drive. And most of the modern digital drive is formatted with exFAT. To clone disk, you should turn off the secure boot first. Secure boot is a security measure built into a system's BIOS to prevent untrustworthy firmware from running. However, your computer may not reboot to the recovery environment.Įxplain: In this case, you probably enable the secure boot in BIOS, but it does not allow this boot path as part of the cloning process. Acronis True Image not cloning after restart. When you clone disk using Acronis True Image within Windows, you will be asked to restart the computer. 3 situations to Acronis True Image WD edition will not clone Keep reading below to learn the different situations and solutions to Acronis True Image WD edition clone not working. Why Acronis WD clone failed? Is it possible to fix it? If not, is there any alternative WD disk cloning software?” – Sunny Bonnell” – Sunny Bonnellĭon't worry about too much and I'll show you how to fix it in this article. But Acronis True Image not cloning after restart. Verify the latest version by opening Acronis True Image for Western Digital, select About, verify "The product is up to date".“I got a new SSD from Western digital and then downloaded the cloning software from their website, but this software always tell me ”Acronis computer restart is required” Whenever I try to clone hard drive with it.Once Acronis True Image for Western Digital has been successfully uninstalled, reboot the computer.Īnswer ID 6550: Install and Uninstall Acronis True Image for Western Digital on WindowsĪnswer ID 30615: Install or Uninstall Acronis True Image for Western Digital on macOS. ![]() If there are issues uninstalling, please refer to Answer ID 16789: Acronis True Image for Western Digital Does Not Complete the Uninstall Process. If "Product activation required" appears again, uninstall Acronis True Image for Western Digital using the OS Add/Remove Programs.To repair Acronis True Image software, please refer to Answer ID 32052: Repair Acronis True Image for Western Digital Installation Software".If the Rescan does not resolve the issue, follow the steps listed below. A network connection must be made to the NAS before the rescue media can connect.Ĭlick the Rescan button under the message.My Cloud OS 5 - the SMB (Server Message Block) protocol is not set correctly.My Cloud Home and Duo are not supported by Acronis True Image for Western Digital.Having an outdated version of Acronis True Image for Western Digital.Incorrect installation of Acronis True Image for Western Digital.One Western Digital branded (WD, SanDisk, G-Technology) storage product must be installed insterally or externally connected to the computer.To this system or can be detected in your local network, then try to renew the license again." Please make sure your new hardware by Western Digital has been attached "No new hardware by Western Digital has been detected. When connecting a Western Digital branded (WD, SanDisk, G-Technology) device the following message appears: "Product activation required." Product Activation Required for Acronis True Image for Western Digital ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |